Important Safety Instructions - Samlexpower SEC-1235CE Installation & Operating Manual

CAUTION !
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING—TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. THERE ARE NO USER
SERVICEABLE PARTS INSIDE—REFER TO QUALIFIED SERVICE PERSONNEL.

IMPORTANT SAFETY INSTRUCTIONS

Please read before using your power supply.
1) It Is recommended that you return your power supply to a qualified dealer for
any service or repair. Incorrect assembly may result in electric shock or fire.
2) To reduce the risk of electric shock, unplug the power supply from the outlet
before attempting any maintenance or cleaning. Turning off controls will not re-
duce this risk.
3) If an extension cord is used, make sure that it has grounded male plug Type
EU1-16P (CEE-7/7, "Schuko") and grounded female receptacle(s) Type EU1-16R
(CEE-7/4, "Schuko"). The size of the current carrying conductors should be such
that they are able to carry at least 5 A for the length of the extension.
4) Place the unit in an area that will allow air to flow freely around the unit. DO NOT
block or obstruct vent openings on the side/bottom of the unit.
5) Keep the unit away from moisture and water.
6) NEVER OPERATE THE UNITS IN PARALLEL
WARNING
! Your power supply should be grounded to reduce the risk of electric
shock. The power supply comes with a detachable power cord that has a
grounded male plug Type EU1-16P (CEE-7/7, "Schuko"). The flat contact strips on
the circumference of the plug get connected to the chassis of the unit. When the
power cord is plugged into the corresponding receptacle Type EU1-16R (CEE-7/
4, "Schuko"), the chassis of the unit is automatically connected to the earth ground
through the equipment grounding conductor that is connected to the spring con-
tacts of the power outlet receptacle Type EU1-16R (CEE-7/4, "Schuko").
The power cord must be plugged into a Type EU1-16R (CEE-7/4, "Schuko") outlet
that is properly installed and grounded in accordance with all local codes and
ordinances. Never alter the power cord that has been provided. If the plug of the
cord will not fit the outlet, have a proper outlet installed by a qualified electrician.
Improper connection can result in risk of electric shock.
DO NOT USE THE POWER SUPLY FOR DIRECT CHARGING OF BATTERY OR DI-
RECT CONNECTION TO A BATTERY FOR BATTERY BACK-UP. (Please read the
section on "Battery Charging and Battery Back-up" on page 5).
2.