Important Safety Instructions - Samlexpower SEC-1235 Installation & Operating Manual

Switch mode dc power supply
Hide thumbs Also See for SEC-1235:
Table of Contents

Advertisement

CAUTION !
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING—TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. THERE ARE NO USER
SERVICEABLE PARTS INSIDE—REFER TO QUALIFIED SERVICE PERSONNEL.

IMPORTANT SAFETY INSTRUCTIONS

Please read before using your power supply.
1) It Is recommended that you return your power supply to a qualified dealer for
any service or repair. Incorrect assembly may result in electric shock or fire.
2) To reduce the risk of electric shock, unplug the power supply from the outlet
before attempting any maintenance or cleaning. Turning off controls will not
reduce this risk.
3) If an extension cord is used, make sure that it has 3-prong, grounded male
plug (NEMA5-15P) and 3-prong, grounded female receptacle (NEMA5-15R).
The size of the current carrying conductors should be such that they are able to
carry at least 10 A for the length of the extension.
4) Place the unit in an area that will allow air to flow freely around the unit. DO
NOT block or obstruct vent openings on the side/bottom of the unit.
5) Keep the unit away from moisture and water.
6) NEVER OPERATE THE UNITS IN PARALLEL
WARNING
! Your power supply should be grounded to reduce the risk of
electric shock. The power supply comes with a detachable power cord that has
a 3 prong, grounded male plug (NEMA5-15P). The round prong of the plug gets
connected to the chassis of the unit. When the power cord is plugged into the
corresponding 3 slot female receptacle (NEMA5-15R), the chassis of the unit is
automatically connected to the earth ground through the equipment grounding
conductor that is connected to the round slot of the female NEMA5-15R
receptacle.
The power cord must be plugged into a NEMA5-15R outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
Never alter the power cord that has been provided. If the plug of the cord will not
fit the outlet, have a proper outlet installed by a qualified electrician. Improper
connection can result in risk of electric shock.
DO NOT USE THE POWER SUPLY FOR DIRECT CHARGING OF BATTERY OR
DIRECT CONNECTION TO A BATTERY FOR BATTERY BACK-UP. ( Please read
the section on "Battery Charging and Battery Back-up" on page 5).
2.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sec-1235m

Table of Contents