Table of Contents
Advertisement
2.2 Recommend Tools
Hammer and nail for hanging remote thermo-hygrometer transmitter.
2.3 Thermo Hygrometer Sensor Set Up
1. Remove the battery door on the back of the sensor by removing the set screw, as shown in
Figure 1.
2. BEFORE inserting the batteries, locate the dip switches on the inside cover of the lid of
the transmitter.
Figure 2 displays all four switches in the OFF position (factory default setting).
3. Channel Number: The WS11 supports up to eight transmitters. To set each channel
number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table
1.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Table 1.
Version 1.0
©Copyright 2014, Ambient LLC. All Rights Reserved.
Figure 1
Figure 2
3
Page
Advertisement
Table of Contents
