Table of Contents
Advertisement
Installation Instructions
(J)
(J)
(B) x 4
Figure 6
2.
Attach CM4 to accessory by aligning the four mounting
buttons attached to the CM4 with the four teardrop
mounting holes on the accessory. (See Figure 7)
Figure 7
3.
Move CM4 forward until all four mounting buttons are
through teardrop mounting holes in accessory.
(See Figure 7)
4.
Lower CM4 until all four mounting buttons are seated into
lower area of teardrop mounting holes in accessory.
5.
Secure the CM4 to the accessory by moving the "Q-Latch"
into the "latched" position. (See Figure 8)
(D) x 4
Mounting button
attached to CM4
Connecting Speaker Wire
The speaker wire for the end speakers is pre-installed in the
CM4. Speaker wire from the wall must be connected to the
CM4.
Teardrop
NOTE:
Mounting
Holes
1.
Connect the speaker wire from the wall to the CM4 speaker
wire interface on the left side (viewed from front of CM4).
(See Figure 9)
Install Display
WARNING:
CAN LEAD TO SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installers responsibility
to ensure the total amount of weight placed on the mount
does not exceed 240 lbs (108.86 kg) the maximum capacity
of the CM4.
WARNING:
BETWEEN MOVING PARTS CAN LEAD TO SEVERE
PERSONAL INJURY! Keep fingers and hands away from
mount when operating.
Q-Latch
Figure 8
The speaker wire for the center speaker is NOT pre-
installed on the CM4. This speaker wire must be
installed and routed from the wall to be attached to the
CM4 center speaker later in the installation process.
Black
Left
Right
Channel
Channel
Red
Figure 9
EXCEEDING MAXIMUM WEIGHT CAPACITY
PINCH HAZARD! FINGERS OR HANDS
CM4
Accessory
7
Advertisement
Table of Contents
