Table of Contents
Advertisement
Quick Links
I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Automated Surround Sound Accessory
This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television
communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a circuit other than that to which the receiver is connected
Consult the dealer or and experienced radio/TV technician for help
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
CM4
Advertisement
Table of Contents
Related Manuals for CHIEF CM4S57
Summary of Contents for CHIEF CM4S57
- Page 1 I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Installationsanleitung Instruções de Instalação Automated Surround Sound Accessory This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
-
Page 2: Important Warnings And Cautions
CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. -
Page 3: Tools Required For Installation
Installation Instructions TOOLS REQUIRED FOR INSTALLATION PARTS R (1) S (1) T (1) B (4) C (18) A (4) 10-24x1/2" 1/4-20x3/8" 5/16x2-1/2" K (2) J (1) M (1) P (1) N (1) U (1) D (4) E (4) F (12) 5/16"... - Page 4 LEGEND Tighten Fastener Apretar elemento de fijación Befestigungsteil festziehen Apertar fixador Serrare il fissaggio Bevestiging vastdraaien Serrez les fixations Loosen Fastener Aflojar elemento de fijación Befestigungsteil lösen Desapertar fixador Allentare il fissaggio Bevestiging losdraaien Desserrez les fixations Hex-Head Wrench Llave de cabeza hexagonal Sechskantschlüssel Chave de cabeça sextavada Chiave esagonale...
-
Page 5: Installation Requirements
Installation Instructions INSTALLATION REQUIREMENTS The CM4 has been designed to be mounted directly onto the wall, or onto an accessory. Power Requirements and Wiring The CM4 requires 120VAC (220/240VAC 50 Hz for European installations) power to operate. A 9 foot long power cable (S) is provided with the mount. INSTALLATION Pre-Installation Configuration The CM4 horizontal movement limits are factory-set to the least... - Page 6 Wall Level Stud (A) X 2 Figure 2 (G) x 4 Figure 3 Attach lower wall bracket (Q) to CM4 (J) using four 5/16" nylon lock nuts (G). (See Figure 3) Place the top of the CM4 onto the upper wall bracket and secure it to the bracket using four 5/16"...
-
Page 7: Install Display
Installation Instructions (B) x 4 Figure 6 Attach CM4 to accessory by aligning the four mounting buttons attached to the CM4 with the four teardrop mounting holes on the accessory. (See Figure 7) Figure 7 Move CM4 forward until all four mounting buttons are through teardrop mounting holes in accessory. - Page 8 WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40 LBS (18.14 KG)! Always use two people and proper lifting techniques when installing or positioning display. Attach interface bracket to back of display following instructions included with the interface bracket. While supporting each side of display, align four mounting buttons on display or interface bracket with four teardrop slots on CM4.
- Page 9 Installation Instructions Speaker Speaker (F) x 2 (optional) Figure 13 Attach brackets (K) with speakers to CM4 speaker arms using two 1/4-20 x 3/8" button head cap screws (C) on each bracket. (See Figure 13) Attaching Center Speaker and Bracket (Optional) NOTE: The optional center speaker bracket may be attached either at the top or bottom of the CM4.
-
Page 10: System Activation
Connect speaker wires from CM4 to left/right (end) speakers. (See Figure 18) NOTE: "+" wire should be attached to red terminal, and "-" to black terminal. Terminal positions will vary with brand of speaker. Speaker wire Back preinstalled of CM4 on CM4 Connect wire to speaker ("+"... - Page 11 Installation Instructions NOTE: If NOT using the full speaker extension, move the Extension Limit Adjustment from the factory preset to the right one inch for each desired additional two inches of overall speaker arm extension (one inch extension for right speaker arm and one inch extension for left speaker arm).
- Page 12 8820-000017 Rev. A 2007 Chief Manufacturing www.chiefmfg.com 06/07 USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands P +31 (0)40 2668620 F +31 (0)40 2668615...
Need help?
Do you have a question about the CM4S57 and is the answer not in the manual?
Questions and answers