CNET CWR-854 User Manual page 21

Mode: This Wireless-G Router supports four operating modes: AP, client, WDS,
-
and AP+WDS.
- Network Type: when operating mode is Client mode, users can select the network
type as "Infrastructure" or "Adhoc" mode.
SSID: The SSID differentiates one WLAN from another, therefore, all wireless
-
access points/routers and all wireless devices attempting to connect to a specific
WLAN must use the same SSID. It is case-sensitive and must not exceed 32
characters.
Regulation Domain: Different countries have different Regulation Domains which
-
allow only specific radio frequencies.
Channel Number: The number of channels supported depends on the region of
-
this Wireless-G Router. All stations communicating with this Wireless-G Router
must use the same channel.
- Associated Clients: When you click on the "Show Active Client" button, it will show
all the clients already associating this Wireless-G Router, see the "Active Wireless
Client Table", only valid for AP mode and AP+WDS mode.
- Enable Mac clone: when operating mode is Client mode and only one Ethernet
client exists, users can enable this Mac clone feature to connect with wireless
station easily.
Apply Changes: Click on "Apply Changes" to save the setting.
-
- Reset: Click on "Reset" button to undo your changes.
Help: To request help information.
-
In the figure above, click on "Site Survey" button, the "Wireless Site Survey" table will display as
below:
Refresh: Click on "Refresh" button to show and renew the table.
-
Connect: You can select the "Select" radio button, and then click on "Connect"
-
button, the connection will be established.
Help: To request help information.
-
In the figure above, click on "Show Active Clients" button while there are wireless clients
connected to this Wireless-G Router. You will see the figure below to show the MAC address,
transmission, reception packet counters and encrypted status for each associated wireless client.
21