Operation - Prem-I-Air EH1920 Manual

The unit has 4 operating modes: Cool, Fan, Dry, Sleep
1. Start up and Shutdown
1.1. Press POWER to turn the unit on (the unit runs in FAN mode as default)
1.2. Press MODE button to select the desired operating mode
1.3. Press POWER again to turn off
Caution!: The unit must only be shut down using the control panel or remote control, never directly unplug
the unit from the mains as this can seriously damage the unit and increase the risk of fire
2. Cooling Mode
2.1. Press MODE button until the COOL LED is illuminated
2.2. Use ADD and MINUS buttons to adjust the temperature which is displayed on the screen. The temperature
can be set between 16°C and 32°C
2.3. Press SPEED button to adjust the fan speed
2.4. To control the direction of the air flow, please adjust the inner louver by hand.
Note: The air conditioner stops if the room temperature is equal to the selected temperature
3. Ventilating your room
3.1. Press MODE button until the FAN LED is illuminated
3.2. Press SPEED button to adjust the fan speed
Note: in ventilation mode the room air is circulated, but not cooled
4. Drying your Room
4.1. Press MODE button until the DRY LED is illuminated
4.2. In this mode the fan speed cannot be adjusted
4.3. It is recommended that the user connects the hose to the drain outlet on the bottom of the unit
5. Sleep Mode
This is only available during cooling mode and can only be activated using the remote control.
5.1. Press the sleep button on the remote control – after one hour the preset temperature is increased by 1°C.
this increases after another hour until the current room temperature is achieved.

OPERATION