Operation - Prem-I-Air EH1672 User Manual

Leave the appliance in an upright position for 3 hours before first use.
Plug the mains lead into a 13 Amp mains socket (unless permanently installed)
If connecting via an extension lead, make sure that the lead is rated at 13 Amps
or more, and that it is fully unwound.
Switch the unit on at the mains socket.
This unit can be operated from the front panel or via the supplied remote control.
Timer
Power Button: Press the
illuminates when the appliance is ON. There will be a short delay (of about a
minute) before the appliance starts to operate.
/ MODE Button: Select the mode by pressing the
available modes are: COOL – DEHUMIDIFY (DRY) – HEAT – FAN – ENERGY
SAVING

/COOL mode: Cools the room to the desired temperature as set on
the remote control or panel using the
can be set between 16C and 30C (60F - 86F) and the fan speed can
be adjusted using the
speed as

/Dry mode: removes humidity (dehumidify), but does not affect room
temperature. The fan operates at its lowest speed shown as

OPERATION

Display Window
Up
Fan Speed
Sleep
Remote Control
/ Power button to start the unit. The
/ FAN buttons, the display will show the fan
/Lo, /Med and
Page 6
Down
Auto Swing
Auto Clean
or buttons. The temperature
/Hi.
Power
Mode
/ MODE button. The
. For best
indicator