Advertisement
CAUTION
Parts of the antenna are an electrical conductor. Contact with power lines can result in death, or serious injury.
Do not install the antenna where there is any possibility of contact with (or high voltage arc-over from) power
cables. The antenna and supporting mast must not be close to any power lines during installation, removal or in
the event that part of the system should accidentally fall.
If the antenna is installed above the roof line or in an exposed location, it is advisable to fit lightning
surge arrestors in the coaxial cable feed line. Suitable units should be sourced and installed as per the
manufacturer instructions. The installer is responsible for determining if this is a requirement for the
antenna installation.
4. Mounting Using the Low Profile Wall Bracket
Offer the antenna to the mounting bracket face, fit the supplied bolts with washers and tighten securely.
Do not over-tighten as it may warp the back plate.
Ensure there are no obstructions or utilities behind the mounting surface. Use the bracket as a template
to mark the mounting hole positions. Select the correct size drill bit to suit the wall plug, drill holes and
insert wall plugs. Align the bracket over the prepared holes, insert screws and fully tighten evenly. Drill
any hole/s required for cable routing as appropriate.
Safety Check: Ensure that the bracket is securely fixed to wall before
fitting the antenna.
Offer the antenna and bracket to the wall mounting tilting the antenna
slightly away from the wall and sliding the two prongs on the antenna
bracket into the locations on the wall bracket until the antenna locates.
Becareful not to trap or damage the cable.
5. Pole Mounting using the Adjustable Bracket
Fit bracket to antenna using supplied screws, washers and nuts. Offer the
multi-tilt bracket to mast in selected position and fit V bolts with washer &
nuts. Tighten by hand to allow final positioning and alignment of the
bracket. Note: directional adjustment in both azimuth (horizontal)[+/-
40deg] and elevation (vertical) [+/-20deg]can be made using the tilt/swivel
feature. Once correctly aligned, fully tighten the V bolts evenly from each
side to secure the bracket.
Caution: Do not overtighten the V bolts as this may damage or distort
the mast tube section.
4
Advertisement
