Download Print this page
Panorama Antennas WM11 Series Installation Manual

Panorama Antennas WM11 Series Installation Manual

Advertisement

Quick Links

Introduction
The WM11 range of high gain, directional antennas provide a simple, cost effective way of improving
the performance of a UMTS or GSM device. For best results, the antenna should be fitted externally
in an elevated position.
Determine a suitable Mounting Location
For a good installation the antenna should be directed towards the strongest network signal to
acheive this follow the guide below.
1. Connect the antenna to your data card or modem with the antenna adapter and coaxial cable
provided.
2. Ensure that your device is connected to the network and displaying the signal strength indicator.
3. With the antenna at selected location, rotate it in approximately 45 degree steps – in each posi-
tion, you may need to wait for up to one minute to allow the signal strength indicator to update.
Note:
Signal strength indication may be displayed either as:
a.
Graphically with bars, ( where more bars is a better signal), or
b.
As a signal level value in dBm (e.g. -80) - in this case, the lower the number, the better the
signal, (i.e. -71 is stronger signal than -83).
Mounting the Antenna Externally
Ensure that the selected mounting location can be safely accessed with the equipment that you have
available and mount the antenna so that it has at least 1 metre of clearance from all obstructions if
possible.
Mount the antenna
The antenna is supplied with weatherproof mounting hardware for wall or mast mounting and
should be fitted with the cable entry at the bottom.
Mast mounting:
The clamp assembly allows fitting to masts of between 20-50mm diameter.
Wall mounting:
The wall mount bracket can be used to mount the WM11 antenna to walls or other
secure flat surfaces. Suitable screws and wall plugs (if required) should be sourced locally.
Secure the antenna in place and waterproof the exposed connections
Fully tighten the mounting hardware, ensuring the antenna direction is correct.
If exposed the RF connector joint should be waterproofed with a weatherproof electrical tape (self
amalgamating type is recommended) allowing a significant overlap of each turn and ensuring that
the overlap is in the opposite direction to predicted water fall.
Panorama Antennas Ltd l Frogmore l London l SW18 1HF l United Kingdom
T: +44 (0)20 8877 4444 l F: +44 (0)20 8877 4477 l E: sales@panorama-antennas.com
The WM11 Antenna Range
Installation Guide

Advertisement

loading

Summary of Contents for Panorama Antennas WM11 Series

  • Page 1 Panorama Antennas Ltd l Frogmore l London l SW18 1HF l United Kingdom T: +44 (0)20 8877 4444 l F: +44 (0)20 8877 4477 l E: sales@panorama-antennas.com...
  • Page 2: Important Safety Information

    The antenna and supporting mast must not be close to any power lines during installation, use or removal. Panorama Antennas Ltd l Frogmore l London l SW18 1HF l United Kingdom T: +44 (0)20 8877 4444 l F: +44 (0)20 8877 4477 l E: sales@panorama-antennas.com...