Weller WX1012 Operating Instructions Manual page 25

8-18
Keys
Control key 1, 2
Press and hold
down keys 10 and 1
or 10 and 2
Press and hold
down keys 2 and 4
or 1 and 4
Selection key 4
Selection key 10
Key 4
Turn-and-click
wheel 5
Enter key 4
*) see also overview diagrams (Fig. 7 / Fig. 8, Page 10).
Fig. 10
Operation
Briefly press key 1, or 2 once
Press and hold down key 1, 2
for 3 sec.
Press and hold down keys 1
and 2 simultaneously
Keys 10 and 1 or 10 and 2
simultaneously
Keys 2 and 4 or 1 and 4
simultaneously
Briefly press key 4 once
Press and hold down keys 10
for 3 sec.
Briefly press key 4 once
Move your finger over the
turn-and-click wheel
Click left or right
Briefly press key 4 once
6.2 Example 1:
adjusting the temperature
1. Press and hold down the required selection key (10) for 3 sec.
The display changes over to the set-point temperature
(see Fig. 10).
2. Set the required set-point temperature with the turn-and-click
wheel (5).
3. Confirm the value with the Enter key (6).
4. Exit the parameter menu with key (4).
Note If no entry is made for 10 seconds, the parameter menu is exited
automatically.
Function
The fixed temperature (24/25)* becomes the
active set-point temperature (22)*.
- Scroll within the Parameter menu
− The active set-point temperature is saved as
the fixed temperature under the key being
pressed (1, 2).
− Channel (9)* is closed or opened
− Open Parameter menu
− Open Parameter menu
− Select auxiliary device, this being a
requirement for opening the parameter
settings of the auxiliary device (e.g. WFE)
− Select auxiliary (WFE front port)
− The set-point temperature window opens
− Exit parameter menu
− Select/set value
− Navigate within a menu
− The set-point temperature window opens for
the soldering tool connected on the left/right
− Confirm value/selection
WX 1