Biostar iDEQ 200T Bios Setup Manual page 23

P4TBA BIOS Setup
When enabled and after the set time of system inactivity, all devices except the CPU will be
shut off.
The Choices: Disabled (default), 1 Min, 2 Min, 4 Min, 8 Min, 12 Min, 20 Min,
30 Min.
HDD Power Down
When enabled, the hard disk drive will power down and after a set time of system inactivity.
All other devices remain active.
The Choices: Disabled (default), 1 Min, 2 Min, 3 Min, 4 Min, 5 Min, 6 Min, 7 Min
HDD Down In Suspend
This item allows you to enable or disable HDD Down In Suspend.
The Choices: Disabled (Default), Enabled.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has "hung."
The Choices: Delay 4 Sec, Instant-Off (default).
Intruder # Detection
This item allows you to disable or enable the Intruder# Detection.
The Choices: Disabled (Default), Enabled.
Wake-Up by PCI card
When you select Enable, a PME signal from PCI card returns the system to Full On state.
The Choices: Disabled (Default), Enabled.
Power-On by Ring
This item allows you to enable or disabled power on by Ring.
The Choices: Disabled (Default), Enabled.
Resume by Alarm
This item allows you to enable or disable Resume by Alarm.
The Choices: Disabled (Default), Enabled.
Reload Global Timer Event
Reload Global Timer Events are I/O events whose occurrence can prevent the system from
entering a power saving mode or can awaken the system from such a mode. In effect, the
system remains alert for anything, which occurs to a device, which is configured as
Enabled, even when the system is in a power down mode.
Primary IDE 0/1
The Choices: Disabled (Default), Enabled.
22