ATEN CL5716I User Manual page 26

CL5708I / CL5716I User Manual
No. Component
1 Handle
2 Slide Release
3 LCD Display
4 LCD Controls
5 Port LEDs
6 Keyboard
7 Touchpad
8 Station/Port
Switches
9 External Mouse
Port
10 Power LED
11 Rack Mounting
Brackets
12 Lock LEDs
13 Reset Switch
14 Firmware
Upgrade
Section
15 USB Port
16 LED Illumination
Light
10
Pull to slide the KVM module out; push to slide the module in
(see item 2 in this table).
In order to slide the console out, you must first release it by
sliding these tabs to the inside. See page 21 for details on
sliding the console in and out.
After sliding the KVM module out, flip up the cover to access
the LCD monitor.
The LCD On/Off switch is located here, as well as buttons to
control the position and picture settings of the LCD display.
See page 25 for details.
An ON LINE LED lights to indicate that the computer
attached to its corresponding port is up and running.
Standard 105-key keyboard
Standard mouse touchpad
Press the UP or DOWN buttons for the Port ID and Station ID
to bring the KVM focus to the computer attached to the
corresponding port. See Manual Port Switching, page 28.
A USB mouse port is provided for users who prefer to use an
external mouse.
Lights to indicate that the unit is receiving power.
The rack mount brackets located at each corner of the unit
secure the chassis to a system rack.
Num Lock, Caps Lock, Scroll Lock LEDs are located here.
Located to the right of the Lock LEDs. Press this recessed
switch in with a small object to perform a system reset.
Firmware Upgrade Port: The Firmware Upgrade Cable
that transfers the firmware upgrade data from the adminis-
trator's computer to the CL5708I / CL5716I plugs into this
RJ-11 connector.
Firmware Upgrade Switch: During normal operation this
switch should be in the NORMAL position. (See The Firm-
ware Upgrade Utility, page 189 for firmware upgrading
details.)
The USB port is available to connect a USB 1.1 peripheral
device (flash drive, CD-ROM drive, etc.) to the switch.
Press the Exit/Light pushbutton for two seconds to turn the
LED light ON or Off. (Default: On)
Description