Juice Extractor Assembly - Cuisinart CFP-800 Series Instruction And Recipe Booklet

JUICE EXTRACTOR
ASSEMBLY
ASSEMBLING THE
JUICE EXTRACTOR
ATTACHMENT ON THE BASE
1. Place the motor housing base
on a fl at, sturdy surface that is
clean and dry. Place the base
of the juice extractor onto the
motor base, with the groove for
the pour spout on the right-
hand side. Line up white arrow
on bottom edge of juice
extractor base with the arrow
on the rim of motor housing
base. To lock extractor base in
place, turn it clockwise to line
up arrow with lock/arrow
on rim of motor housing.
2. Set the clear plastic bowl onto
the base, positioning the pour
spout in the groove.
3. Hold the mesh fi lter basket/
blade carefully by the rim, using
both hands, and place
it into the center opening of
the bowl. Slowly rotate it,
gently pressing down, until
you feel it drop into place.
Push down fi rmly to secure.
4. Place the lid on the bowl.
5. Lift the side latches up to
grasp the lid and press down
to lock them into place.
6. Place the pusher into the lid's
feed tube.
PUTTING THE ASSEMBLED
JUICE EXTRACTOR
ATTACHMENT ONTO THE
MOTOR BASE
1. If juice extractor attachment is stored while
fully assembled, fi rst lift the side latches up to
disengage them from the lid.
2. Place the assembled attachment onto the
housing base with the pour spout on the
right-hand side, and the indicator mark on
the juice extractor base a little forward of the
indicator mark on the motor base.
3. With the juice extractor base seated fi rmly on
the center gear connector in the motor base,
turn the full assembly clockwise to lock it into
place. The indicator marks will line up and the
assembly will stop turning.
4. Lift the side latches up to grasp the lid and
press down to lock them into place.
OPERATING INSTRUCTIONS
1. Press pour spout down into the open position
and place a container under it to catch juice.
2. Wash all fruits and vegetables before juicing.
3. While many items will fi t through the food
tube whole, any with diameters larger than 2¾
inches will need to be cut.
4. Turn dial to Low when ready to begin.
5. Remove the food pusher from the feed tube
and drop items into the opening. Return the
pusher to the tube and press fi rmly to feed
food into the extractor basket.
6. Juice will fl ow through the spout into the juice
container; strained pulp will remain in the bowl.
7. When fi nished juicing, turn the unit to OFF.
8. Before removing the juice container from under
the spout, slide the spout up to the closed
position. This will prevent juice from dripping
onto the counter.
DISASSEMBLING THE
JUICE EXTRACTOR
ATTACHMENT AFTER USE
1. Unplug the unit.
2. Lift the pour spout up to the closed position.
3. Lift the side latches from the bottom to release.
4. Turn the juice extractor assembly counterclock-
wise to remove it from the base.
5. Lift lid up to remove from bowl.
6. Carefully remove mesh fi lter basket/blade from
the fi lter housing by pulling up on the sides
of the rim with both hands. Be careful not to
touch the blades in the bottom of the
basket.
7. Lift the bowl off of the juice extractor base.
8. All removable parts, not including the juicer
base, are top-shelf dishwasher-safe for quick
and easy cleanup.
14