Table of Contents
Advertisement
Installation
Non-Kit Daisy Chain Installation
(B132-004-2, B132-004A-2 and B132-008A-2 only)
Note:
1. For models that support EDID copy, perform the EDID copy procedure described
2. The diagram above shows a B132-004A-2 VGA + Audio Extender/Splitter daisy
3. Test to make sure the entire installation works properly before pulling cables
4. To achieve maximum distance and performance, 24 AWG solid-wire Cat5e/6
5. To achieve maximum resolution, it is recommended that you use Tripp Lite P502-
15-08-104-933289-EN.indd 19
continued
Source PC
in this manual prior to installation.
chain installation. Installation will be the same for non-audio models, except that
an audio source and speakers will not be connected. Also, the number of ports
on transmitters will vary from 4 to 8.
through ceilings/walls.
cable must be used. The use of stranded wire Cat5e/6 cable, or cable with a
gauge (AWG) size higher than 24 AWG, will result in shorter extension distance.
All Tripp Lite N202-Series cables are made with 24 AWG solid-wire cabling.
Tripp Lite N022-01K-GY (Cat5e) and N222-01K-GY (Cat6) are 24 AWG solid-wire
bulk cables. For optimal image quality between 500 and 1,000 ft., use Zero-
Skew cable, such as Tripp Lite P524-01K.
Series VGA video or P504-Series VGA video and audio cables with RGB coax.
Local PC and
Speakers (Optional)
B132-100A-WP-1
B132-004A-2
19
B132-100A
8/21/2015 3:45:50 PM
Advertisement
Table of Contents
