Installing The Belt Cover And The Bobbin Winder; Lubrication - JUKI DSC-245 Instruction Manual

3.INSTALLING THE BELT COVER AND THE BOBBIN WINDER

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
❶
❷

4.LUBRICATION

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
(Installing procedure)
1. Insert support ❶ of the belt cover into
the tapped hole in the machine arm.
Install belt cover support ❷ and belt
cover support plate ❸ in the tapped
holes in the machine bed.
2. Set locknut ❺ in synchronizer support
shaft ❹ and install it in the tapped
hole in the machine arm.
3. Install belt cover ❻ .
4. Fit bobbin winder ❼ in the belt cov-
er,and adjust the position of the bobbin
winder so that it does not come in con-
tact with the sewing machine and the
belt cover. Then fix the bobbin winder
using the wooden screws.
5. Install cover ❽ of the belt cover.
6. Tilt the machine head and check that
the belt cover does not come in contact
with the belt groove in the table
(Caution)
Tilt the machine head after removing the
hook for the knee lifter.
● Before starting the sewing machine
Prior to operation,be sure to properly lubricate the points
marked with the arrow.
(Caution)
About lubrication to section
lubricate after pulling top cover of the bed
you.
– 3 –
A
: In DSC-245V,-4,-7,
❶
toward