Table of Contents
Advertisement
ASSEMBLY
Chain Guards
The FX-318/FX-212 comes standard with single or double chain guards. Use the Parts Manual for chain guard
locations on the rotary cutter.
If your machine is equipped with single safety chains insert the first link of the 5 link chain into the first slot of
the chain rail. If your machine is equipped with double safety chains (9 links) insert the 5 middle link into the
first slot of the chain rail. Once you have the link inserted slide the 1/4" rod into the link. Continue along the
length of the chain rail until all links are inserted.
Bend the end 2" of the galvanized rod back to keep the chains from falling loose.
Tires
To reduce the possibility of the laminations separating, laminated tires should be installed with the laminations
orientated as shown.
Always install the laminated or aircraft tires onto the wheel hub with a lockwasher and with the flat side of the
nut seated against the lockwasher.
NOTE: Torque 1/2" wheel nuts to 85 ft. lbs.
FX-318 - FX212 08/21
Assembly Section 3-3
© 2021 Alamo Group Inc.
Advertisement
Table of Contents
