Table of Contents
Advertisement
GENERAL ASSEMBLY
Check oil level in all gearboxes before operation. Refer to the 'Lubrication' section of this
manual for recommended oil type and viscosity.
Lubricate all grease fittings. Refer to the grease schedule in this manual. Check that all nuts and bolts are in
place and properly tightened. Refer to the 'Maintenance' section of this manual for required bolt grades and
torques.
Check that all tires are inflated to proper specifications. Refer to the 'Maintenance' section of this manual for
required tire pressures.
Wheel Arm Installation
To avoid serious injury or death, be sure the axle clamp plate is at least 3" minimum away
from the beam pivot plate.
1 . Space the wheel arms as wide as possible to meet your specifications and secure the top clamp plate as
shown. (Asm-R-0785)
2 . Adjust arm position as needed before tightening bolts.
3 . For FX-212 machines, make sure the red line on right side of the decal is NOT covered. (Asm-R-0786)
4 . Torque all bolts and re-torque to confirm both sides of the clamps are secure.
FX-318 - FX212 08/21
© 2021 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-2
Advertisement
Table of Contents
