Ilsco TaskMaster TB-12U1000-P Instruction Manual page 15

TB-12U1000-P
ADVANCE TRIGGER AND RELEASE BUTTON
1. The ram moves forward when the trigger is pressed and stops when the trigger is released.
2. To retract the ram, push the reverse trigger. The ram continues to retract as the release button
is held down.
1
CRIMPING
1. Retract the ram fully by pressing the release button.
2. Insert dies by pressing die release buttons and sliding die into ram, then releasing the buttons
until the die clicks into place.
3. Place the connector between the dies.
4. Press the advance trigger and advance the ram so that the connector is held between the dies
and insert conductor into the terminal.
5. Press the advance trigger until the compression is completed. A clacking sound will be heard
while crimping. Once the clacking stops the crimp is completed.
6. Press the release button to retract the ram. The ram continues to retract while the
release button is pressed. The ram stops when it reaches the end of the head.
NOTE: Ram can be retracted without battery in the tool.
5
7. Remove dies when crimp is complete by pressing die release buttons.
MAX.
click!
2
7
2
NOTE: Reverse trigger on both sides of tool
6
15