Advertisement
Figure 2. Mounting to an Electrical Backbox
Figure 3. Mounting to a Wall Stud
Interconnections
The only method of powering a VIP-148AL-IC
IP Paging Horn is via a Power over Ethernet
(PoE) switch or power injector meeting the
802.3af specification.
Make all required signal connections before
connecting to Ethernet switch or power injector
meeting the 802.3af specification.
Signal Connections
Audio output connection is made from the Signal
Output. The RJ-45 connector on the horn is
connected directly to the RJ-45 Signal Output
socket on the Network Interface. If additional
length is required, any standard T568B
extension may be used. See Figure 4.
Network Connection
As shown in Figure 4, the Network Interface has
one RJ-45 network connector on the front panel.
Use a standard Ethernet patch cable to connect
the NETWORK connector of the Network
Interface to an 802.3af compliant PoE port
(100m maximum distance).
Status Indicator Lights
The IP Link has 2 status indication lights located
on network jack.
Green LED: (Link) Indicates Ethernet
connection when illuminated.
Yellow LED: (Activity) Indicator flashes to
indicate network activity.
Setup
The VIP-148AL-IC will automatically acquire an
IP address (using DHCP) and connect to the
InformaCast server when connected to the
network and powered up. Information specific to
your application will need to be programmed into
the InformaCast server. Refer to the
InformaCast documentation for further
information.
2
947823
Advertisement
