Eneo IAR-7SE1024MMC Quick Installation Manual page 6

Led Indicators Instructions
Indicators
Main Power Supply
PWR1
Indicator
Redundant Power
PWR2
Supply Indicator
1~24 Downlink Port Link
Indicator
25~28 Uplink Port Link
Indicator
Console Port
The device contains a serial RS-232 interface as the console port for local management
interface. For the console port, a standard RJ-45 connector is used. Use a RS-232
calbe (Sub-D9 to RJ-45) to connect the console port with the COM port of a PC.
Default configuration:
Data
Transfer rate
Flow control mode
Test mode
Stop bits
Data bits
Init Button
The init button has two operating modes.

By short pressing the button, the switch will be reset and the configuration is as
previous setting saved.

By pressing the button over 5s, the switch will be restored to the original factory
default setting.
Status Descriptions
On The Main Power Supply is working.
Off The Main Power Supply is off.
On The Redundant Power Supply is working.
Off The Redundant Power Supply is off.
On The port is linking normally.
Blink The port is transmitting or receiving data.
Off The port links down.
On The port is linking normally.
Blink The port is transmitting or receiving data.
Off The port links down.
Default value
115200 bit/s
Not support
Not support
1
8
3