Daikin STREAMER C55WVM Operation Manual page 12

Read First
Preparation Before Operation
3
Preparing the remote controller
1.
Attach the remote controller holder.
• Insert the hook on the remote controller holder into
the notch in the back of the unit.
Notch
Insert all the way.
2.
Pull out the transparent sheet.
• After removing the transparent sheet, the remote
controller is ready for use.
Battery is
pre-loaded
How to use
• Direct the signal transmitter on the remote controller at
the signal receiver on the unit. The unit may fail to receive
signals if anything is blocking the signals, such as a
curtain.
• Maximum transmission range is approx. 6m (straight line).
Signal
receiver
About the remote controller
• Be sure not to drop or allow water to get into the remote
controller. (Malfunction may result)
• Signal reception may be poor in rooms with electronic-
starter-type fluorescent lamps (inverter-type fluorescent
lamps etc.).
• Do not use near lighting equipment (within 1m).
(A decline in the receptivity of the signal from the remote
controller or discolouration may result)
4
Inserting the power supply plug into the socket
• The basic sensitivity of the odour sensor will be determined by odour
levels in the first minute (approx.) after the power supply plug is
inserted every time.
Insert the power supply plug when the air is clean (odour-free).
11
Transparent
sheet
[Viewed from above]
Signal
transmitter
Approx. 4m Approx. 4m
30° 30°
Approx. 6m
Replacing the battery
1.
Move the catch on the battery tray at the
bottom of the remote controller in the
direction of the arrow.
2.
Pull out the battery tray.
Hook
3.
Replace the battery.
4.
Return the battery tray to its original position.
Catch
About the battery
• Keep batteries out of reach of children.
In the event that batteries are swallowed, go immediately
to the nearest medical emergency services.
• To avoid possible injury or damage from battery leakage
or rupturing, remove the battery when not using the
product for a prolonged period.
• If the battery solution should get in the eyes, do not rub
the eyes. Instead, immediately flush the eyes with tap
water and seek the attention of a medical professional.
• Do not expose batteries to heat or fire. Do not
disassemble or modify batteries.
The insulation or other parts inside the battery may be
damaged, resulting in battery leakage, rupturing or
overheating.
• When disposing of the battery, insulate the terminal by
wrapping it in tape etc.
(Overheating, rupturing or fire may result if stored
together with other metal objects or batteries)
Observe local waste separation rules when disposing
of batteries.
• While the general battery replacement timing is once a
year, if signal reception weakens, the battery should be
replaced with a new battery (CR2025).
• Batteries with an expiration date that is close may
require replacement sooner.
• The pre-loaded battery is for initial use of the unit and
may require replacement in less than 1 year.
3
Battery (CR2025)
2 4
Load so that battery + side and side of
+
battery tray with mark face same direction
Power supply plug
Power socket
+
mark