Table of Contents
Advertisement
2.4 Cable Connection
2.4.1 Device Connection
U s e c r o s s n e t w o r k c a b l e o r c r o s s - o v e r c a b l e t o c o n n e c t P C o r
other device with switch's Ethernet port;
2.4.2 Configuration Cable Connection
If web management,use a network cable to connect the OOB port and the
computer 'RJ45 port;
If CLS management,use a console cable to connect the Console port and
the computer 'serial port(DB9);
as the following figure:
Figure 2-5 Connect configuration cable
2.4.3 Power cable Connection
( 1 Connect one side of switch's power cable with the switch's AC power port,
)
and connect the another side with external AC power socket;
(2)Turn on the power ,c
heck if switch's AC power LED is on, that means
power connected correctly;
( 3)Use the power plug snap to jammed the AC Power cable.
Figure 2-6 Connect power cable
9
3 Function Configuration Guide
3.1 Computer Requirements
Make sure the management PC has already been installed with Ethernet adapter;
Use network cable connect Ethernet ports with network card of PC(Except the
console port).
3.2 Set Up Network Connection
Instruction
(1) You need to set the IP of the PC and the switch in the same
network segment. The default IP address of the switch is 192.168.1.200,
network gate is 255.255.255.0.
(2) The port to connect management PC for Web setting must be
management VLAN. By default, management VLAN is VLAN 1,and each
port of the switch is VLAN1.
(3) If you need to connect the remote network, please make sure the
management PC and the router can do the job above.
(4) This product can't assign the IP address for the management PC, you
need to set the management static IP by yourself
3.2.1 Set Static IP for the Management Computer
Operation steps (take Windows XP as sample)：
(1) Click <start> to enter the [start]
menu, select "control panel". Double
click "network connection" icon,
double click the "local connection"
icon, pop out "local connection
status" window.
.
10
Advertisement
Table of Contents
