Table of Contents
Advertisement
Manual channel search
In manual channel search, you can enter the channels to be searched directly.
In the Installation menu, move the cursor using the buttons
and press the OK button. The following menu will appear:
Channel search
Antenna
Search mode
Encrypted
Modulation
Symbolrate
Channel
Start scan
This is how to perform a manual channel search:
Select the line Antenna using
Select the line Search mode using
In the line Encrypted, select whether the channel search should also include encrypted
channels, using the ◄ or ► buttons.
No = encrypted channels will be ignored.
Yes = encrypted channels will be included in the search.
In the line Frequency, use the ◄ ► buttons to select the channel that should be searched.
Move the cursor onto the line Start channel search using the
process by pressing the OK button.
Now two windows are shown, listing the newly found TV and radio programmes. The "Status"
window shows how far the search has progressed.
- Display: Scanning => Search is active
- Display: Complete => Search is finished.
You can leave this menu by pressing EXIT. If not finished, the channel search algorithm is
aborted. If new channels are found, you are asked to store them (Yes). Select your choice by
◄/► and confirm with OK. If selected YES the new channels are stored at the end of the
channel list now.
Installation – Factory reset
This menu item allows you to reset the receiver to its default factory status. Afterwards the
receiver starts up with the Welcome Screen (initial installation) again.
Cable
manually
No
QAM 64
6.900MS
7 (191.5MHz)
and Terrestrial using the ◄ or ► buttons.
and Transponder using the ◄ or ► buttons.
- 19 -
Installation
onto the line Channel search
buttons and start the search
-
Advertisement
Table of Contents
