Operating The Hard Disk - Setting And Managing Markers - Triax C-HD207CG Manual

Operating the hard disk – setting and managing markers
During the timeshift function or playback, you can mark places on the recording. A marker is
shown as a coloured triangle in the status indicator. Press the button F1 at the playback
position to set a marker.
You can use the button F2 to show a list of all the markers. A recording always has the
markers Start and End
Using you can now select a single marker. Press the OK button to continue playback at
the selected marker.
When the list of markers is open, you can use the button
marker, so that when playback reaches this marker the function is automatically performed.
You can assign the following functions to markers:
- Press the button
reaches a loop marker, it jumps to the previous marker. A loop marker is labelled L in the
list of markers. A yellow vertical line is shown in the status indicator.
- Press the button
reaches a jump marker, it jumps to the next marker. A jump marker is labelled J in the list
of markers. A white vertical line is shown in the status indicator. Use jump markers, e.g. to
jump over commercial breaks.
- Press the button
during playback as place for a loop or jump.
Press the red button to delete the selected marker from the list. The Start and End markers
cannot be deleted.
Press the F2 button or EXIT to close the list.
.
once – the marker is interpreted as a loop. When the playback
twice – the marker becomes a jump marker. When the playback
three times – this marker has no special function, but can be used

to assign a particular function to a
00:17:22
- 28 -
00:20:30
1 00:00:00 Start
2 00:03:11 Mark1 J
3 00:08:58 Mark2
4 00:12:01 Mark3 L
5 00:20:30 End