Information; Teletext - Triax C-HD207CG Manual

If you push one of the buttons
Choose „Yes" to stop the record or „No" to continue the record.
Hint: Please make sure that the local time of the receiver is set correctly and the video
recorder is programmed, too.

Information

Enter the main menu, there use
In the upper section of the menu the channel parameters of the activated channel are
displayed.
In the lower section of the menu the signal qualities are displayed.
- C/N:
- Level:
Hint:
The power of the signal depends on the antenna set up and also on the currently activated
channel. Please remember this if you want adjust your antenna by controlling the signal
power.
After pressing the ◄ ► or the yellow button two further charts with channel, software and
hardware information are displayed. With
Use EXIT to leave this menu.

Teletext

Press the TEXT button to display the videotext of the current channel. The first site to be seen
is site number "100".
In order to view a specific page, use the buttons 0-9 to enter the three-digit page number. Your
input is displayed in the left corner on the screen. When the site number is input completely
the receiver starts to search the corresponding site. Because the video text sites are sent site
by site it may take some seconds until the required site is found. Enter "100" at any time to
return to the home page of the videotext.
You may use
channel.
If you press the TEXT button again you can switch into the mixed mode (background
transparent). Use the TEXT button to return to the normal mode.
For leaving the video text please press EXIT.
- 22 -22
Record active. Stop?
Yes No
The further the bar turns right and the higher the dB value, the better
the signal quality.
The further the bar turns right the better the reception.
to quickly page through the complete videotext section of a particular TV
or ◄►, following menu appears:
to select line Information and press OK.
you can change the channel.
- 23 -
Information