Manual Search; Channel Filter - Triax TR 112 Operating Manual

After selecting the "Auto Search" page, the
receiver will scan all frequencies one by one for
the selected country.
During scanning, you can press the "EXIT" key to
stop the scanning process and exit.
If any programmes are detected and the scanning
process has finished the system will exit the
scanning page, save the programmes and return
to the "installation menu", this is shown below:

Manual Search

If you know the frequency of the channels, or
if you want to scan a channel at a particular
frequency, you can select manual search.
Move the cursor to "Manual Search" using the
"UP/DOWN" key when in the "installation menu",
press "ENTER" to select the manual search page,
this is shown in the picture below:
To carry out a manual search, you need to
configure the relevant parameters including:
(1) Frequency (kHz): The default frequency
depends on the selected country, you can input
relevant information to modify it.
(2) Bandwidth: The default value of bandwidth
depends on the selected country. It can be set to
6 MHz,7 MHz, or 8 MHz.
(3) Press the "ENTER" key after configuration to
start manual scan.
(4) Press the 'EXIT' key to return to normal
viewing.

Channel Filter

A scan of all channels or free to air only channels
can be selected, this is illustrated in the picture
below:
16