2.2.7.
Fuser Unit
CAUTION:
To prevent from getting burned, do not install, remove, clean or make adjustments when the Fuser Unit is
hot.
Ver. 2.1
(1) Remove the Inner Cover Assembly. (Refer to
2.2.6.)
(2) Disconnect 2 Harnesses by pressing down on
the connector latches with a small screw driver.
(3) Open the Rear Cover.
(4) Remove 4 Screws (T9).
(5) Remove the Upper Exit Roller Holder (1201).
(6) Remove 1 Screw (Y3).
(7) Remove the Fuser Harness Cover (1023).
(8) Disconnect the Harness on the LVPS.
56
UF-7000/8000
UF-7100/8100
APR 2007