Panasonic UF-8100 Service Manual page 129

Hide thumbs Also See for UF-8100:
Table of Contents

Advertisement

Code
Mode
582
XMT
601
XMT
623
XMT
630 XMT or RCV
(Polling)
631
XMT
634
XMT
638
XMT
700
XMT
RCV
711
RCV
712
XMT
714
XMT
RCV
715
XMT
716
XMT
717
XMT
Ver. 2.1
Fax Information Codes
Phase
Description of Problem
B
Sub-address SEP (for Polling)
transmission to a unit that has their
DIS bit 47 (NSF bit 130) OFF.
ADF Door was opened during ADF
transmission.
A
No original was in the ADF. (Built-
in dialer engaged)
B
Redial count over.
A
"STOP" button was pressed during
Auto Dialing.
B
Redial count over with no
response or busy tone was not
detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
LAN
Power turned Off with applicable
data in memory or during
communication.
PSTN
Communication terminated by
LAN
Operator pressing the "STOP" key.
LAN
Incorrect LDAP settings.
LAN
Unknown email address replied
from the Mail Server.
LAN
LAN Interface error.
Cannot logon to the LAN.
LAN
TCP/IP connection timed out.
LAN
Cannot logon to the LAN.
LAN
Incomplete SMTP Protocol
transmission.
Sub-address transmission to a unit that
has no Sub-address function.
Operator removed the original from the
ADF after dialing was completed.
Original was not set properly in the ADF.
No dial tone detected. Sensor dial tone
is not detected. (Destination dependent)
Busy tone is detected. (Destination
dependent) T1 timer (35 ± 5 sec.)
elapsed without a signal from the
receiver.
Telephone line cable is disconnected.
Wrong number is dialed.
SC or FXB PCB is abnormal.
Power switched off.
Power failure occurred.
LDAP Server Name, LDAP Login
Name, LDAP Password and/or LDAP
Search Base are incorrect.
Mail Server received an incorrect email
address. (Dependent on Server's Mail
application)
The 10Base-T/100Base-TX cable is not
connected.
An unexpected LAN problem occurred.
Check the SC PCB connector.
Incorrect IP Address is set.
Verify the IP Address, Default Router IP
Address, SMTP Server IP Address.
Incorrect SMTP Server IP Address is
set.
No email application is activated on the
Mail Server.
Mail Server's hard disk may be full.
Mail Server is defective.
129
UF-7000/8000
UF-7100/8100
Cause
APR 2007

Advertisement

Table of Contents
loading

This manual is also suitable for:

Uf-8000Uf-7100Uf-7000

Table of Contents