TRENDnet User's Guide
Network Management
A broad range of network configurations are supported by: 802.3ad link aggregation,
802.1Q VLAN, bandwidth controls, IGMP, loopback detection, port mirroring and 802.1p
(QoS).
Troubleshooting
Traffic statistics and a convenient cable diagnostic test aid in network troubleshooting.
© Copyright 2018 TRENDnet. All Rights Reserved.
Product Hardware Features
Console Port
Reset Button
Smart fans
•
LED on/off – Press and hold to turn LED lights on or off
•
LED Indicators – Indicator for device Power and System status.
•
10GBASE-T Ethernet Ports (1-8) – Connect network devices or servers
•
Console Port – – Use the included RJ-45 to RS-232 serial console cable to
access the out-of-band command line interface management.
•
Reset Button- Press and hold this button for 8 seconds and release to
reset the switch to factory defaults. The ports LEDs will turn off to
indicate that the reset was initiated.
•
Power Port – Connect the power cord to start up the device (supports
AC 100 – 240V, 50-60Hz)
TEG-7080ES
LED on/off
10GBASE-T ports
Power port
2