Cable Diagnostics Test; Enable Ieee 802.3Az Power Saving Mode - TRENDnet TEG-7080ES User Manual

TRENDnet User's Guide

Cable Diagnostics Test

Tools > Cable Diagnostics
The switch provides a basic cable diagnostic tool in the GUI for verifying the pairs in
copper cabling and estimated distance for troubleshooting purposes.
1. Log into your switch management page (see
on page 7).
2. Click on Tools and click on Cable Diagnostic.
3. Click on the Start button to run the cable diagnostic.
The results will be displayed in the Cable Diagnostic Table.
•
Test Results: Displays the diagnostic results for each pair in the cable. One of the
following cable status parameters is displayed:
o
Healthy: There is no problem detected with the cable.
o
Open: There is an open wire within the cable.
o
Short: Two wires are shorted together within the cable.
•
Clear: The Clear button can be used to clear the Cable Diagnostic test results.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"

Enable IEEE 802.3az Power Saving Mode

Tools > IEEE 802.3az EEE
The IEEE 802.3 EEE standard defines mechanisms and protocols intended to reduce the
energy consumption of network links during periods of low utilization, by transitioning
interfaces into a low-power state without interrupting the network connection. The
transmitted and received sides should be IEEE802.3az EEE compliance. By default, the
switch disabled the IEEE 802.3az EEE function. Users can enable this feature via the
IEEE802.3az EEE setting page.
1. Log into your switch management page (see
on page 7).
2. Click on Tools and click on IEEE 802.3az EEE
3. Click the IEEE 802.3az EEE Status drop-down list and select Enabled to enable the
power saving feature and click Apply to save the settings.
TEG-7080ES
"Access your switch management page"
23