Table of Contents
Advertisement
7. Connect the corresponding cables, such as power
cord, and video cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Pan Position
[0° to 360°]
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.2 Mounting with Inclined Ceiling Mount
Before you start:
You need to purchase an inclined ceiling mount
separately.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill screw holes, and the cable hole on the
ceiling/wall according to the supplied drill template.
3. Disassemble the inclined ceiling mount by the screw
driver.
4. Install the turret camera's mounting base on the
inclined ceiling mount's cover with three PM4
screws.
Figure 2-6 Install Turret Camera's Mounting Base
5. Install the inclined ceiling mount's body on the
ceiling/wall with four PA4 × 25 screws, as shown in
Figure 2-8.
Tilt Position
[0°to 75°]
Figure 2-4 3-axis Adjustment
Figure 2-5 The Drill Template
Rotation Position
[0°to 360°]
Screw Hole
Cable
Hole
Advertisement
Table of Contents
