Advertisement
N. B :Installation in compliance with the consumption declaration
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed . If the double oven rests on a continuous ,flat
surface ,there must be an aperture of at least 15×560mm .
The panels of the adjacent cabinets must be made of heat-resistant material .In particular ,cabinets with a veneer exterior must be assembled
with glues which can withstand temperatures of up to 100℃.
In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it has
been installed.
All parts, which ensure the safe operation of the appliance, must be removable only with the aid of a tool.
To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden screws into the 4 holes located on the
perimeter of the frame.
Electrical Connection
Those double ovens equipped with a three-pole power supply cable are designed to operate with an alternating current .The wire for earthling
the appliance is yellow-green in color.
Fitting on a Power Supply Cable
Opening the terminal board:
· Using a screwdriver ,prize the bolt on the side tabs of the cable board cover ;
· Using a screwdriver unhooking the no.2fixing hooks(A-B), pull open the cover of the terminal board.
To install the cable, proceed as follows:
· Remove the wire clamp screw and the three contact screws L-N-
· Fasten the wires beneath the screw heads using the following color scheme :Blue (N) Brown (L) Yellow-Green
· Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When connecting the cable directly to the mains, install an
omni polar circuit breaker with a minimum contact opening of 3 mm between the appliance and the mains .The omni polar circuit breaker
Advertisement
