Problem
Image is not stable
Message : No signal
The power LED is a or-
ange color
Contacting service
If the above troubleshooting hints do not help you find a solution to the problem, contact
an authorized service agent. If the monitor is sent for service, use the original package if
possible.
Unplug the display unit from the power outlet and contact a service agent when:
• The monitor does not operate normally according to the operating instructions.
• The monitor exhibits a distinct change in performance.
• The monitor has been dropped or the cabinet has been damaged.
• The monitor has been exposed to rain, or water or liquid has been spilled onto the
monitor.
www.prestigio.biz
P171_eng.indd
Possible solution
If the setting is not correct, use your computer utility program
to change the display settings.
Check that the signal cabel connector is properly connected
and that the connection pins are not bent or damaged.
If the connector is loose, tighten the connector's screws.
Check that the computer is switched on.
To enter a power saving mode. You can reactivate the system
by pressing any key or moving the mouse.
LED Indicator can be orange color on changeing of video mode
or Input Signal(D-sub/DVI).
Check the Resolution and the frequency on the video part
of your computer. Compare these values with the data in the
Preset Timing Table.
15
15
16.10.2003, 0:36
Eng