Page 2
Networks warrants that software will operate substantially in accordance with its functional specifications for 90 days and that it has been properly recorded on non-defective media. Fluke Networks does not warrant that software will be error free or operate without interruption.
Good safety practices prohibit the normally associated with craft tools. connection of the TS19 and similar test sets to 117 volts AC commercial electrical power; The back of the handgrip is contoured and has a...
RING for ringer and low impedance monitoring, and TALK for talk. The TS19 comes with either a standard cord or an In the HI Z position, the TS19 is on hook with a angled bed-of nails cord (see below). The line high impedance coupling to the telephone line.
TS19 when the two Portable Test Telephone leads are placed on battery potential and ground respectively, or across the terminal of an electrically charged capacitor.
On the field side of the fault, no click will be heard. Place the TS19 on a firm and level working surface with the keypad up. To locate an open circuit: Bridge the test set across the circuit line —...
TS19 Portable Test Telephone Users Guide Specifications Electrical Loop Limit 2.4 k maximum at 48 VDC (nominal 15 mA minimum loop current) DC Resistance (Talk Mode) typical at 80 mA current AC Impedance (Monitor Mode) Low impedance (Ring position) 600...
Need help?
Do you have a question about the TS19 and is the answer not in the manual?
Questions and answers