Fluke TS54 Quick Start Manual

Toner and SmartTone Function
The toner helps you identify wire pairs and find
cables in bundles, at patch panels, or behind
walls.
Connect the test leads to two wires in a cable.
M
Press , then select
probe to find the place where the tone is the
loudest.
If there is voltage on the line, the display shows
SmartTone Volt Detect Lock Out
not operate.
The SmartTone function helps you make sure
you correctly identify a wire pair. When you put
a short on the correct pair, the tone changes.
Standard VOPs
M
Press , select TDR
VOP Twisted Pair Cable Types
68 Gel Filled19 AWG
64 Gel Filled 22 AWG
62 Gel Filled 24 AWG
60 Gel Filled 26 AWG
68 Paper 22 AWG
66 Paper 24 AWG
65 Paper 26 AWG
72 PIC 19 AWG
67 PIC 22 AWG
66 PIC 24 AWG (default)
64 PIC 26 AWG
SmartTone
. Use a tone
, and toner will
, then select VOP Setting
TS 54 TDR Test Set Users Card
®
Data Test / Lockout Override
Connect the test set to Tip and Ring. Press
If data is present, a warning beep sounds, and
the test set does not go off-hook, and the
display shows
hook, press
Polarity
: The polarity of Tip and Ring is reversed.
+
Redial the Last Number Dialed
Press
P
Speed Dial a Stored Number
Press
P
of the memory location where the number is
stored.
.
Volume
Press
C D
speaker that is on.
Menu
Press
M
item or save a setting, press
select
Back
• : A phonebook of nine stored numbers
Contacts
for the speed dialing function. The number in
memory location 9 is the number for the ANAC
function.
Data Detect Lockout
.
$
. Press .
L
. Press . Press the key (
R
to adjust the volume of the
. To scroll, press
C D
M
or press .
Q
August 2011, Rev. 3 2/2017
©2011, 2015, 2017 Fluke Corporation
.
P
. To go off-
through )
1 9
. To select an
again. To exit,
PN 3836378