Table of Contents
Advertisement
USB Ports
USB 9
USB 14
USB 7
USB 8
USB 2.0
U
USB 4
USB 2
USB 3
U
USB 1
USB 3.1 Gen1
USB 3.1 Gen1
CS100-H310
USB 2
USB 4
USB 1
USB 3
USB 3.1 Gen2
UBS 3.1 Gen1
CS100-Q370/C246
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with 4 onboard USB 2.0 ports (USB 7, 8, 9, 14) and 4 onboard
USB 3.1 ports (USB 1, 2, 3, 4). The additional USB ports may be mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear of the system chassis
and then insert the USB port cables to a connector.
BIOS Setting
Configure these onboard USB devices in the Advanced menu ("USB Configuration" submenu)
of the BIOS. Refer to the chapter 3 for more information.
Chapter 2 Hardware Installation
Chapter 2
Graphics Interfaces
The display ports consist of the following:
•
1 VGA port
•
2 DP++ ports
VGA
VGA
DP++
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
DP++ Port
The DisplayPort is a digital display interface used to connect a display device such as a com-
puter monitor. It is used to transmit audio and video simultaneously. The interface, which is
developed by VESA, delivers higher performance features than any other digital interface.
Driver Installation
Install the graphics driver. Refer to the chapter 4 for more information.
21
www.dfi .com
Advertisement
Table of Contents
