Table of Contents
Advertisement
Block Diagram
R.G.B
DDI
VGA
PTN3355
DDI
LVDS
DDI
DP++
PCIe x1
MDI
GLAN I219LM
USB 3.1 Gen 2
USB 2.0
PCIe x1
MDI
GLAN I211AT
USB 3.1 Gen 1
USB 2.0
USB 2.0
LPC
Super I/O with WDT
FAN Control
H/W Monitor
Case Open
Audio Jack
(Line-out, Mic-in)
Co-layout
(Jack w/ Line-in)
S/PDIF
Front Audio
Chapter 2 Hardware Installation
Chapter 2
Channel A
2666MHz
DDR4 DIMM 2x
Channel B
LGA 1151
2666MHz
DDR4 DIMM 2x
PCIe x16
PCIe x16 1x
SATA 3.0
Full Size
USB 2.0
Mini PCIe
PCIe x1
Q370/
SMBus
C246/
Digital I/O 8-bit
H310
SMBus
SPI Bus
SPI BIOS
SATA 3.0
SATA 3x
LPC
LPC Header
DTPM 2.0 (opt.)
ALC888
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
System Memory
Important:
When the Standby Power LED lights red, it indicates that there is power on the
system board. Power-off the PC then unplug the power cord prior to installing any de-
vices. Failure to do so will cause severe damage to the motherboard and components.
Features
•
Two 260-pin SODIMM up to 32GB
•
Dual Channel DDR4 2400/2666MHz
10
Standby Power LED
DDR4_1 SODIMM
DDR4_2 SODIMM
www.dfi .com
Advertisement
Table of Contents
