Rear Panel I/O Ports; Dc-In (Ku171)/9~36V Dc-In (Ku173) - DFI KU173 User Manual

Rear Panel I/O Ports

LAN 1 LAN 2
DC-in DP++ 1 DP++ 2
The rear panel I/O ports consist of the following:
• 1 12V DC-in jack (default) - KU171
• 1 9~36V DC-in jack (default) - KU173
• 2 DP++ ports
• 2 RJ45 LAN ports
• 4 USB 3.0 ports
• 1 Line-out jack
• 1 Mic-in jack
Chapter 2 Hardware Installation
Chapter 2
USB 3.0
Mic-in
Line-out
16
12V DC-in (KU171)/9~36V DC-in (KU173)
DC-in
Connect a DC power cord to the DC-in jack. Using a voltage more than the recommended
range may fail to boot the system or cause damage to the system board.
The DC-in jack on the system board co-lays with a 4-pin right angle connector (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
4-pin Right Angle
(optional)
4-pin Vertical Type (optional)
DC-in (default)
www.dfi .com