Chassis Intrusion Connector; Front Panel Connector - DFI HD330-Q87 User Manual

Chassis Intrusion Connector

COM 2
COM 1
The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
Chapter 2 Hardware Installation
Chapter 2

Front Panel Connector

Chassis
1 2
Intrusion
Signal
Ground
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
HDD-LED
RESET SW
26
COM 2
COM 1
Pin Pin Assignment
3 HDD Power
5 Signal
PWR-LED
7 Ground
9 RST Signal
ATX-SW
11 N.C.
1 2
PWR-LED
Front
HDD-LED
Panel
ATX-SW
RESET-SW
11 12
Pin Pin Assignment
2 LED Power
4 LED Power
6 Signal
8 Ground
10 Signal
www.dfi .com