Cooling Fan Connectors; Power Connectors - DFI HD330-Q87 User Manual

Cooling Fan Connectors

COM 2
COM 1
These fan connectors are used to connect cooling fans. The cooling fans will provide adequate
airflow throughout the chassis to prevent overheating the CPU and system board components.
BIOS Setting
The Advanced menu ("PC Health Status" submenu) of the BIOS will display the current speed
of the cooling fans. Refer to chapter 3 for more information.
Chapter 2 Hardware Installation
Chapter 2
CPU Fan
1 4
Ground Speed Control
Power
Sense
System Fan 2
1 3
System Fan 1
1
Ground
Power
Sense
3

Power Connectors

COM 2
COM 1
Use a power supply that complies with the ATX12V Power Supply Design Guide Version 1.1.
An ATX12V power supply unit has a standard 24-pin ATX main power connector that must be
inserted into the 24-pin connector. The 8-pin +12V power connector enables the delivery of
more +12VDC current to the processor's Voltage Regulator Module (VRM).
The power connectors from the power supply unit are designed to fit the 24-pin and 8-pin
connectors in only one orientation. Make sure to find the proper orientation before plugging
the connectors.
The system board requires a minimum of 300 Watt power supply to operate. Your system
configuration (CPU power, amount of memory, add-in cards, peripherals, etc.) may exceed the
minimum power requirement. To ensure that adequate power is provided, we strongly recom-
mend that you use a minimum of 400 Watt (or greater) power supply.
Important:
Insufficient power supplied to the system may result in instability or the add-in boards
and peripherals not functioning properly. Calculating the system's approximate power
usage is important to ensure that the power supply meets the system's consumption
requirements.
25
+12V 1 5
Power
Ground +12V
4 8
12 24
GND
+3.3V
+12V +5V
ATX
+12V +5V
Power
+5V
+5VSB
PWR_OK -5V
GND
GND
GND
+5V
GND GND
+5V PS_ON#
GND
GND
+3.3V -12V
+3.3V +3.3V
1 13
www.dfi .com