Installing The Dimm Module - DFI HD330-Q87 User Manual

Microatx industrial
Table of Contents

Advertisement

The system board supports the following memory interface.
Single Channel (SC)
Data will be accessed in chunks of 64 bits (8B) from the memory channels.
Dual Channel (DC)
Data will be accessed in chunks of 128 bits from the memory channels. Dual channel provides
better system performance because it doubles the data transfer rate.
DIMMs are on the same channel.
DIMMs in a channel can be identical or
Single Channel
completely different. However, we highly
recommend using identical DIMMs.
Not all slots need to be populated.
DIMMs of the same memory configuration
Dual Channel
are on different channels.
Important:
You can populate either Channel A or Channel B first.
Chapter 2 Hardware Installation
Chapter 2

Installing the DIMM Module

Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
1. Make sure the PC and all other peripheral devices connected to it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the DIMM socket on the system board.
4. Push the "ejector tabs" which are at the ends of the socket to the side.
Ejector tab
5. Note how the module is keyed to the socket.
10
Ejector tab
Notch
Key
www.dfi .com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hd330Hd330-h81bHd330-h81cHd330-h81dHd330-q87cr

Table of Contents