Standby Power Led; S/Pdif Connector - DFI HD330 User Manual

Standby Power LED

This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
Chapter 2 Hardware Installation
Chapter 2

S/PDIF Connector

Standby Power LED
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
27
SPDIF out
S/PDIF
Key Ground
SPDIF in
+5V
1 5
www.dfi .com