Rj45 Lan Ports; Usb Ports - DFI HD330 User Manual

RJ45 LAN Ports

LAN 1 LAN 2
LAN 1
LAN 2
Features
• Intel I210 PCI Express Gigabit Ethernet controller
®
• Intel I217LM Gigabit Ethernet Phy
®
The LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN ports in the Chipset menu ("PCH-IO Configuration" submenu) of
the BIOS. Refer to the chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to the chapter 4 for more information.
Note:
HD330-H81B supports the Intel ® 217LM Gigabit Ethernet Phy
Chapter 2 Hardware Installation
Chapter 2

USB Ports

USB 1
USB 0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with two onboard USB 3.0/2.0/1.1 ports (USB 0-1) and four
onboard USB 2.0/1.1 ports (USB 4-5/8-9). The 10-pin connector allows you to connect 2 addi-
tional USB 2.0/1.1 ports (USB 2-3). The additional USB ports may be mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear of the system chassis and
then insert the USB port cables to a connector.
BIOS Setting
controller (LAN 1) only.
Configure these onboard USB devices in the Advanced menu ("USB Configuration" submenu)
of the BIOS. Refer to the chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your system operation to use the USB device.
Refer to your operating system's manual or documentation for more information.
22
USB 9
USB 8
USB 2.0
USB 5
USB 4
USB 3.0 USB 2.0
USB 2-3
9 1
10
2
USB 2.0
www.dfi .com