Table of Contents
Advertisement
3)
On the Connect To screen, change the Connect using value to the COM port the modem is connected to and click
OK.
4)
On the COM Properties screen, change the Bits per second value to 115200. Leave all the other options
untouched (8, None, 1, Hardware), and click OK.
You should now be able to send AT commands. You will not see what you type until you send the command ATE1 or
enable echo in HyperTerminal's settings, but the commands will still be sent to the modem. Send ATI1 and confirm that
you see the words "BlueTree Wireless" in the response.
Advertisement
Table of Contents
Troubleshooting
