red lion IndustrialPro BT-6600 Quick Start Manual

OVERVIEW
The IndustrialPro™ BT-6600 series modems are rugged wireless
modems built to provide simple and reliable communication over
Alltel's CDMA EVDO Rev A wireless data network.
This guide covers initial activation and configuration of the following
models:
BT-6600
FEATURES
• CDMA EVDO Rev.A, 1XRTT, and IS95
• Diversity antenna
• EVDO Rev. A speeds of up to 3.1 Mbps
• Ethernet, Serial, and USB
• Reliable Always-on cellular link
• Rugged electrical and mechanical design
• Remote diagnostics, configuration and updates
• Router and IP Pass-through modes
• 5-port Ethernet switch (on BT-6621)
• Power over Ethernet (on BT-6601EB)
• IPsec VPN multiple tunnel and 3DES|AES up to 256-bit encryption
POWER
The modem has a 4-pin Molex connector for power input and requires
a power source between 8 and 30 VDC.
LABEL DESCRIPTION
GND Ground
POS Power 8 to 30 VDC (12 or 24 VDC nominal)
IGN Ignition sense
O3 Digital output
* An AC-DC power adaptor can be purchased as an accessory.
ANTENNA
An antenna with an SMA connector should be connected to the
modem. This antenna should meet the following specifications:
• Dual-band 800 & 1900 MHz
• Nominal 50 ohm impedance
• Voltage Standing Wave Radio (VSWR) less than 2.5:1
*Antennas are sold separately.
CONNECT. MONITOR. CONTROL.
BT6601 & BT-6601EB
BT-6621
© 2014 Red Lion Controls. All Rights Reserved
IndustrialPro
DATA INTERFACES
Ethernet: 10/100 Mbps Auto-sensing Female RJ45 port
USB: USB 2.0 Type B Female
Serial: RS-232 9 pin DCE Female, with these default settings:
• Speed: 115200 bps
• Data bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: Hardware
LED INDICATORS
LED State Description
Power ON Power is applied to the router
ON Excellent signal strength
Signal FLASH Flashes faster as signal is stronger
OFF Very weak or no signal (less than -100dBm)
ON Wireless link established, but no data activity
WAN
FLASH Data transmitted/received on wireless network
Link established with serial device but no data
ON
activity
RS232
Data transmitted/received with attached serial
FLASH
device
ON Position fix available
GPS
OFF No position fix available
Ethernet
ON Link established with Ethernet device
Link
Ethernet Data transmitted/received with attached Ethernet
FLASH
Activity device
ADDITIONAL INFORMATION
Visit our support page at www.redlion.net
mentation, as well as configuration help, troubleshooting and firmware
& software updates. Or contact Technical Support at 1-877-432-9908 or
support@redlion.net.
SETUP
1. Setup a data account for the modem
Contact your AERIS dealer and request a data account to be assigned to
the modem's ESN (electronic serial number). The ESN is printed on
modem's label.
2. Wiring and power-up
1. Connect the modem to your computer using a standard Ethernet cable.
Alternatively, the RS-232 or USB ports can be used for setup.
2. Connect the cellular antenna to the antenna connector.
3. Plug in the power connector to power-up the modem.

QUICK START GUIDE

TM BT-6600 Series
Aeris Wireless Modem
to access the modem's docu-
1