red lion MobilityPro BT-5800 Series Quick Start Manual

OVERVIEW
The MobilityProTM BT-5800 modems are rugged 3G wireless modems
built to provide simple and reliable communication over the HSDPA/
HSUPA or EDGE cellular data network.
This guide covers initial configuration for the BT-5800 & BT-5830.
FEATURES
• HSDPA/HSUPA with fallback to EDGE/GPRS
• Diversity antenna
• Ethernet, Serial, USB and WiFi (5830 model only)
• Reliable Always-on cellular link
• Rugged industrial design
• Remote diagnostics, configuration and updates
• 3 Analog inputs, 4 digital inputs, 3 digital outputs
• IPSec VPN multiple tunnel and 3DES|AES up to 256-bit encryption
LED INDICATORS
LED State Description
Power ON Power is applied to the router
ON Excellent signal strength
Signal FLASH Flashes faster as signal is stonger
OFF Very weak or no signal (less than -100dBm)
ON Wireless link established, but no data activity
WAN
FLASH Data transmitted/received on wireless network
ON Link established with serial device but no data
activity
RS232
FLASH Data transmitted/received with attached serial
device
ON Position fix available
GPS
OFF No position fix available
Ethernet ON Link established with Ethernet device
Link
Ethernet FLASH Data transmitted/received with attached
Activity Ethernet device
ADDITIONAL INFORMATION
Visit our support page at www.redlion.net to access the Modem User's
Guide for an in-depth overview of the modem's features and capabili-
ties, as well as configuration help and troubleshooting. Contact Techni-
cal Support at 1-877-432-9908 or support@redlion.net.
CONNECT. MONITOR. CONTROL.
POWER
The modem has a 4-pin Molex connector for power input and requires
a power source between 8 and 30 VDC.
LABEL
GND
POS
IGN
O3
ANTENNA
An antenna with an SMA connector should be connected to the
modem. This antenna should meet the following specifications:
• Dual-band 800 & 1900 MHz
• Nominal 50 ohm impedance
• Voltage Standing Wave Radio (VSWR) less than 2.5:1
*Antennas are sold separately.
DATA INTERFACES
Ethernet: 10/100 Mbps Auto-sensing Female RJ45 port
USB: USB 2.0 Type B Female
Serial: RS-232 9 pin DCE Female, with these default settings:
• Speed: 115200 bps
• Data bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: Hardware
SETUP
1. Setup a data account for the modem
Contact your cellular provider (carrier) and request a data account. The
carrier should provide you with a SIM card to insert into the modem,
along with the APN/usrename/password for data connectivity.
2. Insert the SIM card
1. Locate the SIM slot on the right side of the unit.
2. Insert the card with its cut side facing forward and on the left.
3. Using the tip of a pen, push it in until it clicks.
© 2014 Red Lion Controls. All Rights Reserved
QUICK START GUIDE
MobilityPro
DESCRIPTION
Ground
Power 8 to 30 VDC (12 or 24 VDC nominal)
Ignition sense
Digital output
TM BT-5800 Series
Wireless Modem
1