red lion IndustrialPro BT-6601EB Quick Start Manual

OVERVIEW
The IndustrialPro™ BT-6600 series modems are rugged wireless
modems built to provide simple and reliable communication over
Telus' CDMA EVDO Rev A wireless data network.
This guide covers initial activation and configuration of the following
models:
BT-6600
FEATURES
• CDMA EVDO Rev.A, 1XRTT, and IS95
• Diversity antenna
• EVDO Rev. A speeds of up to 3.1 Mbps
• Ethernet, Serial, and USB
• Reliable Always-on cellular link
• Rugged electrical and mechanical design
• Remote diagnostics, configuration and updates
• Router and IP Pass-through modes
• 5-port Ethernet switch (on BT-6621)
• Power over Ethernet (on BT-6601EB)
• IPsec VPN multiple tunnel and 3DES|AES up to 256-bit encryption
LED INDICATORS
LED State Description
Power ON Power is applied to the router
ON Excellent signal strength
Signal FLASH Flashes faster as signal is stronger
OFF Very weak or no signal (less than -100dBm)
ON Wireless link established, but no data activity
WAN
FLASH Data transmitted/received on wireless network
Link established with serial device but no data
ON
activity
RS232
Data transmitted/received with attached serial
FLASH
device
ON Position fix available
GPS
OFF No position fix available
Ethernet
ON Link established with Ethernet device
Link
Ethernet Data transmitted/received with attached Ethernet
FLASH
Activity device
CONNECT. MONITOR. CONTROL.
BT6601 & BT-6601EB
BT-6621
© 2014 Red Lion Controls. All Rights Reserved
IndustrialPro
POWER
There are 4 methods to provide power to the modem:
1. 4-pin Molex connector - available on BT-6x00
2. 4-pin screw terminal - available on BT-6xx1/EB
3. Side mounted 2.5mm barrel connectors - available on all models
4. Power-over-Ethernet - available on BT-6x01EB
The modem requires a power source between 8 and 30 VDC to operate:
LABEL DESCRIPTION
GND Ground
PWR+ Power 8 to 30 VDC (12 or 24 VDC nominal)
IN Digital input
OUT Digital output
* An AC-DC power adaptor can be purchased as an accessory.
ANTENNA
An antenna with an SMA connector should be connected to the
modem. This antenna should meet the following specifications:
• Dual-band 800 & 1900 MHz
• Nominal 50 ohm impedance
• Voltage Standing Wave Radio (VSWR) less than 2.5:1
*Antennas are sold separately.
DATA INTERFACES
Ethernet: 10/100 Mbps Auto-sensing Female RJ45 port
USB: USB 2.0 Type B Female
Serial: RS-232 9 pin DCE Female, with these default settings:
Speed: 115200 bps
Parity: None
Flow Control: Hardware
SETUP
1. Setup a data account for the modem
Contact your Telus dealer and request a data account to be assigned to
the modem's ESN (electronic serial number). The ESN is printed on
modem's label.
2. Wiring and power-up
1. Connect the modem to your computer using a standard Ethernet cable.
Alternatively, the RS-232 or USB ports can be used for setup.
2. Connect the cellular antenna to the antenna connector.
3. Plug in the power connector to power-up the modem.
QUICK START GUIDE
TM BT-6600 Series
Telus Wireless Modem
Data bits: 8
Stop Bits: 1
1