Table of Contents
Advertisement
•
Make sure all couplers are wiped clean before
connection.
•
The hydraulic circuit control valve must be in
the "OFF" position when coupling or uncoupling
hydraulic tools. Failure to do so may result in
damage to the quick couples and cause overheating
of the hydraulic system.
•
Always store the tool in a clean dry space, safe from
damage or pilferage.
•
Make sure the circuit PRESSURE hose (with male
quick disconnect) is connected to the "IN" port. The
circuit RETURN hose (with female quick disconnect)
is connected to the opposite port. Do not reverse
circuit flow. This can cause damage to internal seals.
•
Always replace hoses, couplings and other parts
with replacement parts recommended by STANLEY.
Supply hoses must have a minimum working
pressure rating of 2500 psi/172 bar.
12 ► SK58 User Manual
TOOL PROTECTION & CARE
In addition to the safety precautions found in
this manual, observe the following for equipment
protection and care.
•
Do not exceed the rated flow. Rapid failure of the
internal seals may result. See Specifications in this
manual for correct flow rate and model number.
•
Always keep critical tool markings, such as warning
stickers and tags, legible.
•
Keep tool bit sharp for maximum drilling performance.
Make sure that tool bits are not chipped or rounded
on the striking end.
•
Never operate a hammer drill without a tool bit or
without holding it against the work surface.
•
Tool repair should be performed by experienced
personnel only.
•
Make certain that the recommended relief valves
are installed in the pressure side of the system.
•
Do not use the tool for applications for which it was
not intended.
Advertisement
Table of Contents
