Hardware Installation - D-Link DHP-W310 User Manual

Powerline av 500 wireless n mini extender

Table of Contents

Section 2 - Installation

Hardware Installation

Note: A minimum of two PowerLine devices (your DHP-W310AV and another pre-existing device) are required to create a PowerLine network.

Power

Plug the DHP-W310AV into an AC wall outlet where you want to extend your network. The Power LED on the DHP-W310AV will turn on to indicate

it is receiving power. This may take up to 60 seconds.

Plug in the Ethernet Cable

Connect one end of the supplied CAT5 Ethernet cable to the Ethernet port on the DHP-W310AV and the other end of the cable to the device's

Ethernet interface.

Connect to Existing Network

Press the Common Connect Button on the existing PowerLine AV device for 3 seconds. Then, press the Common Connect Button on the DHP-

W310AV PowerLine AV 500 Wireless N Mini Extender for 3 seconds. This must be done within two minutes after pressing the Common Connect

Button on the first device. The PowerLine devices will reboot. Read the Wi-Fi advice on the next page, and continue to Configuration.

Note: Network connectivity is confirmed when the PowerLine LEDs indicators on both PowerLine devices are steadily lit. This will indicate that your

network is now secure.

ROOM A

ROOM B

ROOM C

DHP-308AV

iPad

Internet

Router

Notebook

DHP-W310AV

D-Link DHP-W310AV User Manual

Table of Contents

Dhp-w310av